Karcher MC 6420 User Manual - page 18
18 | EN
USB Operation
General Operation
PLAY / PAUSE
►||
Press to start playing tracks from the USB.
Press again to stop playing USB operation temporarily.
Press again to resume playback.
SKIP +
►►| & SKIP - |◄◄
Press to go to the next track or back to the previous track.
Press and hold while playing until you find the point of the sound.
STOP ■
Press to stop all USB operation.
Playback
1.
Plug or slot in USB device to the port. (Make sure no disc on disc tray)
2.
Set the “FUNCTION” selector to “CD / MP3 / USB” mode.
3.
Press and hold the “PLAY / PAUSE” button for a few seconds to entry USB mode.
4.
Playback will start automatically from the first track.
5.
Press the “STOP” button when finished.
6.
Press the “PLAY / PAUSE” button again, playback will start from the first track.
Program, Mode
The operation of PROGRAM, MODE are as the same as that of CD / MP3. Please refer to CD / MP3
OPERATION.
NOTE:
•
A USB device must always be connected directly to the USB port of this product. The use of a
USB extension cord is not supported by this product. The USB port of this product cannot com-
municate with a computer directly.
Other Features
Clock Setting
1.
Clock setting is only available in standby mode.
2.
Press and hold PLAY/PAUSE button for 3 seconds to enter the clock setting mode.
3.
Press SKIP+ / SKIP- button to set the desire time.
4.
Press PLAY/PAUSE button to confirm.
5.
Repeat steps 2 & 3 to set 12/24 hr, hour and minute.
AUX In
1.
Use a 3.5mm Male-to-Male Stereo cable (not included) to connect any external audio device with
a 3.5 mm Headphone or Line-Out jack to the AUX IN jack on the front panel of the stereo.
2.
Switch the unit on (“CD/MP3/USB” or “Radio” mode).
3.
Start playback on the external audio device. Adjust the volume on the audio device (do not set
the volume too high to avoid distortion). You may also adjust the volume on the appliance.
4.
To control playback function, use the controls provided by the external audio device.