Karcher Puzzi 400 K Operating Instructions Manual - page 8
English
Puzzi 400 K
12
Cleaning methods
Normal dirty carpets
•
Spray cleaning solution and use
suction immediately
•
Using suction again shortens the
drying time
Very dirty carpets
•
Only spray cleaning solution
•
Wait 10-15 min.
•
Use suction to remove cleaning
solution
Cleaning upholstery
•
Attach the hand nozzle (special
attachment) instead of floor nozzle
for cleaning upholstery
•
Use the appropriate attachments
for cleaning steps, wall carpets, or
motor vehicle-interiors
•
For sensitive materials use lower
amounts of the cleaning agent,
spray the surface from
approx. 200 mm away. Then only
vacuum it
Rinsing
•
One obtains a better result when
the surface to be cleaned is rinsed
again with clear water
For continuous operation adjust
the metering valve to "0"
•
Remains of the cleaning agent
and loosened dirt are then rinsed
out
Working tips
•
The more sensitive the carpet, the
smaller the amount of cleaning
agent
•
Carpets with jute backings can
shrink and the colours can bleed if
the treatment is too wet
•
High pile carpets should be
brushed off first
•
Cleaning with warm water (up to
max. 50°C) is more effective.
Check the temperature stability of
the surface to be cleaned.
•
Spray very dirty areas beforehand
•
Work from light to dark areas
(from window to doors)
•
Work from clean areas to dirty
ones
•
Treat carpet with Care Tex
RM 762 after cleaning
(accessory).
•
Wait until cleaned surface is dry
before walking on it
•
Use de-foaming agent RM
761 (accessory) for shampooed
carpets.
After operation
Storage
After continuous operation
¾
Turn off the fresh water supply
¾
Turn off switch 3 (waste disposal
pump)
¾
Disconnect the supply and
disposal hose connections from
the unit
¾
Close the waste disposal
connection
¾
Vacuum the not used cleansing
liquid out of the tank with the
suction hose
¾
Remove the floor nozzle and hold
suction hose in a fresh-water tank.
Switch on suction switch. The
cleaning fluid removed by suction
is collected in the dirty-water tank
¾
Adjust the metering valve to "0"
and empty the float tank by
actuating the valve hand
(this also thoroughly rinses the
unit)
¾
Empty the dirty-water tank
¾
Switch off unit and pull the power
plug
After intermittent operation
¾
Vacuum the not used cleansing
liquid out of the tank with the
suction hose
¾
Remove the floor nozzle and hold
suction hose in a fresh-water tank.
Switch on suction switch. The
cleaning fluid removed by suction
is collected in the dirty-water tank
¾
Empty the dirty-water tank
¾
Fill up the tank with 5 l of clean
water
¾
Turn on switch 2 (spraying)
¾
Actuate the valve handle and
thoroughly rinse the unit
¾
Switch off unit and pull the power
plug