KDS Models KDS-7XII Instruction Manual - Part 1 Quick Start
KDS
KDS
KDS
KDS-
--
-7X
7X
7X
7XII
II
II
II
Radio Control
Radio Control
Radio Control
Radio Control System Manual
System Manual
System Manual
System Manual
- 3 -
battery warning systems, intended only as a precaution, to tell you when to recharge. Always
check your transmitter and receiver batteries prior to each flight.
Before flying, be sure that the frequency you intend to fly with is not in use, and secure any
frequency control device (pin, tag, etc.) for that frequency before turning on your transmitter.
It is never possible to fly two or more models on the same frequency at the same time. Even
though there are different types of modulation (AM, FM, PCM), only one model may be
flown on a single frequency at any one time.
While you are getting ready to fly, if you place your transmitter on the ground, be sure that
the wind won’t tip it over. If it is knocked over, the throttle stick may be accidentally moved,
causing the engine to speed up. Also, damage to your transmitter may occur.
Before taxiing, be sure to extend the transmitter antenna to its full length. A collapsed
antenna will reduce your flying range and cause loss of control. It is a good idea to avoid
pointing the transmitter antenna directly at the model, since the signal is weakest in that
direction.
Don’t fly in the rain! Water or moisture may enter the transmitter through the antenna or stick
openings and cause erratic operation or loss of control. If you must fly in wet weather during
a contest, be sure to cover your transmitter with a plastic bag or waterproof barrier. Never fly
if lightning is expected.
Part 1 Quick Start
KDS-7XII IS ADVANCED ELECTRONIC DEVICE, AND FEATURES WIDE USE. It can
support multi-users and multi-equipment simultaneously, and features quick response, high
precision, and strong capability for anti-jamming.
KDS-7XII supports one transmitter and several receivers, and makes it possible that single radio
can control several models.
KDS-7XII supports different brand gyros.
KDS-7XII reacts quickly and precisely.
1. Mounting of Receiver
Installation position shall follow these conditions:
1. Keep the receiver away from engine, motor, ESC, battery, and other metal parts.
2. The antenna can not be covered by metal, carbon material or other electronic conduction
materials.
Keep the antenna in 90 degrees with installed frame or bottom plate, which means that trying to
keep the antenna visible.