KDS Models KDS-7XII Instruction Manual - 4. Control Distance
KDS
KDS
KDS
KDS-
--
-7X
7X
7X
7XII
II
II
II
Radio Control
Radio Control
Radio Control
Radio Control System Manual
System Manual
System Manual
System Manual
- 5 -
3) After few seconds, binding will finish, the LED of receiver will shine three times slowly,
and then the transmitter enters working mode.
4) Release 'ESC' button of transmitter, it will enter working mode.
Notice:
1) KDS-7XII supports multiple receivers operation and long-distance binding, so please make sure
only you bind the radio at that time. If there is any person who also uses KDS-7XII 2.4GHz
remote controller system locally, please operates only after other users pare the signal.
2) KDS-7XII supports seven models saving in one transmitter. They are numbering as M/1 to M/7.
The binding will save the serial numbers in receiver. So if you bind one receiver with M/1, it
can only work when the transmitter is switched to M/1.
4. Control Distance
All radio control system equipment has an effective control range. It’s not the same on the ground,
water surface or flying in the sky; It is not the same on flat ground or complicated layout; It’s not
the same in rainy days or sunny days; And besides, the external electrical environment is changing
continuously. It’s quite necessary for the users who want to control at a long distance to test
effective distance beforehand.
Radio wave transfers almost in a straight line, please make sure there is no object between antenna
and the controlled model. And the antenna should point at receiver’s antenna, and keep the
controlled model in certain distance where you can see the model.
Part 2 User Manual
1 Features
1.LCD display
2.Support 7 models parameters store
3.Support 5 points throttle (THR) curve
in NORMAL mode and IDLE mode.
4.Support 5 points pitch (PIT) curve in NORMAL mode, IDLE mode and HOLD mode.
5.Support HELI (helicopter) mode and AERO mode. Following
modes are supported in each
mode: