Summary of K20
Page 1
K20 installation instructions care and firing instructions.
Page 2: Contents
Contents exploded diagram ...........................................................................................................2 general information......................................................................................................3 important points.............................
Page 3: General
General thank you for choosing our masonry stove! Keddy's masonry stoves have a number of unique characteristics, for example: * flat-ground hatches * good heat storage * cast iron and concrete for long service life the keddy k20 has the following accessories: * outdoor air connector * fire walls * ...
Page 4: Preconditions
Preconditions - 4 - building notice when you install a stove and erect a chimney, you may need to give building notice to the local planning and building committee. Contact the planning and building committee in your municipality for up-to- date information. Surface keddy's heavy masonry stoves (k10...
Page 5: Preparations
- 5 - preparations 1. Floor plate and outdoor air connec- tion arrange the floor plate according to the instructions on page 4 under the heading floor plate. If you choose to make your own floor plate, the minimum dimensions stated in the above-mentioned point must be followed at all times. The illu...
Page 6: Installation Instructions
- 6 - before starting: the final thickness of all mortared joints must be 10 mm, both to walls and be- tween the parts. Check at every stage that the parts have been installed level. It is a good idea to use the dimensions on page 12 to check your construction height. For putting the stove together,...
Page 7: Installation Instructions
- 7 - installation instructions 5. It is now time to place the hearth on to element 2. If outdoor air is to be connected, the outdoor air sleeve must be installed on the hearth (see the instructions in the accessory box for the outdoor air kit.) to facilitate the installation of the hearth, you can ...
Page 8
8. Install the first element, no. 5. Centre it on ele- ment, no. 4. Install the s-bend using jointing compound. 9. Install a further element no. 5 in mortar. Install pipe 330 mm. 10. Install a further three elements no 5 and one ele- ment no 6 in mortar. Install pipe 390 mm. K20 rear connection 11. ...
Page 9
12. Install elements no. 7b, 8b and 9b in mortar. Secure the connection sleeve with insulation in the hole on the front. Let the connection sleeve protrude an equal distance to the thickness of the rendering (approx. 10 mm) test fit the hot air grilles. Note! The grilles must not be cemented into pl...
Page 10: Care & Firing Instructions
Care & firing instructions the keddy k20 has been tested by a certified testing institute. It has extremely good envi- ronmental values and a useful efficiency exceeding 80%. For the stove to work optimally, it is of key importance that you follow the care and firing instructions below. Non-complian...
Page 11
Lighting a fire 1. Open the door by pulling on the fixed handle under the edge of the door. Then, lay kindling across this until you have a total quantity of firewood of approx. 2.0 kg. (approx. 15-20 pieces of kindling) (see pic- ture below) 2. Push the damper control as far to the right as it will...
Page 12: Dimensions
Rev 1, 01/07/2015 dimensions k20 technical specification dimensions and performance height 2170 mm width 920/1020 mm depth 570 mm weight k20 850 kg height, centre rear connection 1905 mm height, top connection 2170 mm outer dimensions, connection ∅150 mm efficiency 83 % nominal output 7 kw output 5-...