KEDDY K20 Installation Instructions Manual - Installation Instructions
- 7 -
INSTALLATION INSTRUCTIONS
5. It is now time to place the hearth on to element
2. If outdoor air is to be connected, the outdoor
air sleeve must be installed on the hearth (see the
instructions in the accessory box for the outdoor air
kit.) To facilitate the installation of the hearth, you can
choose to unscrew and separate the body from the
front/door. This reduces the weight of the hearth by
just over 40 kg.
Open the door fully. Unscrew the four bolts in each
corner. After this, carefully pull the front towards you
until it comes free from the two guide rails. Care-
fully put the front to one side, to avoid damage to the
opening handle. The front and door weigh approx. 40
kg.
Place the feet of the hearth on the places marked on
element 1-11. A suitable place to check horizontally
and vertically with the help of a spirit level is on the
hearth's sealing plate.
Tip!
The stove is vertical and horizontal when the
door stays open at an opening angle greater than
90-95 degrees and when it closes automatically at an
opening angle less than 85-90 degrees.
Where applicable, connect outdoor air to the hearth.
6. Protect the hearth from damp and mortar by wrap-
ping it in plastic during installation.
After this, assemble the four elements 3 in mortar 50
mm from the side of element 2. Place the L-shaped
angled plate, with the short angle pointing up, com-
pletely against the wall between the upper elements
no. 3.
Test the fit for the frame for wall installation. This is
installed permanently after rendering and painting the
stove.
NOTE! The frame for the wall installation must
not be cemented into place; instead, it must be
clamped securely using the springs, otherwise,
there is a risk that cracks will form.
7. Assemble element 4.
Assemble the transition pipe 125-150 mm using joint-
ing compound.