KEDDY K800 Series Installation Instructions Manual - page 11
7. If the chimney is to be installed on top, the
chimney must be installed now. Connect the
start module using sealant. Make sure that the
joint is sealed by sticking your hand into the
stove and spreading the sealant.
NOTE! Always leave at least 5 mm of ven-
tilated space between the top of the stove
and the chimney's insulation/outer steel
jacket. (See the illustration.)
The first section of the chimney is normally half-
insulated (approx. 30-mm insulation). However,
where it passes through the joists, the chimney
becomes fully insulated (approx. 60 mm of
insulation). For additional information about the
installation of the chimney, please, refer to the
installation instructions for the brand of chimney
you have selected.
8. Install the hearth plates, the grate and the
ash pan. For illustration, see points 2 and 4 on
page 7.
9. Assemble the base glass and connect the
electric cable to the socket on the rear base
plate.
You have now made your stove ready for use. In order for the sealant to harden properly, you must
leave the stove for at least three days before firing it for the first time. Since you have bought a stove
that also includes a lot of new technology, we will explain the function of the damper in the next sec-
tion.
- 11 -