KEDDY K800 Series Installation Instructions Manual - page 8
5. Dismantle the top part. If the top is made of cast
iron, the two rear screws must be removed, as shown
in the illustration, before you can remove the top.
If the top is made of concrete/stone, it only needs to
be lifted straight up, since it located vertically against
back plate in order to be centred laterally afterwards.
Then, remove the top ring.
6. Remove the side panels by loosening the retaining
screws. Keep a hand on the panels during this op-
eration, to prevent them from falling on the floor.
Please note that the lower part of the cast iron panel
are located with two heels that fit into two holes in the
stove body.
If the panel is made of stone/concrete, there a groove
that locates onto two elevations in the stove body.
You have now removed all of the necessary parts and
can unscrew the stove and move it into the house.
NOTE! Because the stove is heavy and is also
equipped with adjustment screws under the base, it
can be a good idea to take a piece of the packaging to
stand the stove on, in order to protect the floor while
manoeuvring it into position.
Concrete panel guide
- 8 -
CAST IRON TOP
CONCRETE/STONE TOP
TOP RING
TOP RING
BACK PLATE