KEENCUT ARTIST plus Instruction Manual - page 7
7
User Instructions
Bevel Cutting - Setting The Limit Stops
GB
Lift the cutter bar using the handle.
Place the matboard coloured face down on the slip mat.
Ensure the two mat edges are aligned against the mat
guide and end plate.
Lower the cutter bar to clamp the mat board and check
the mat board contact with the mat guide and End Plate.
THE LIMIT STOPS on the Artist plus are colour coded for ease of explanation. Do not alter the cursor
settings at this stage, adjust the limit stops by means of the large black wing knob only, we will explain the
cursor adjustment later.
Place your slip mat in position.
Lock the Matguide Limit Stop (blue pointer) on 3 (cms or
inches) - this sets the border width.
Matguide Limit Stop
Blue Pointer
Lock the Start of Cut Limit Stop (green pointer) on 3
(cms or inches) - this will position the blade in the
correct place when you start cutting.
Lock the End of Cut Limit Stop (red pointer) on 3 (cms
or inches) - this stops the blade in the correct position
Start of Cut
Limit Stop
Green Pointer
Red Pointer
End of Cut
Limit Stop
End Plate
Matguide