KEENCUT ARTIST plus Instruction Manual - page 9
9
User Instructions
Bevel Cutting - Using The Limit Stops 2
GB
All the stops have now been adjusted and set to cut an accurate mat for
thickness of mat board you have selected.
The following instructions assume
the border width of the mat is set at
3cm (3”) as before.
Inspect the corners on the
coloured side of the mat and
decide if the overcut or undercut
appears at the start or the end of
the cut - remember the matboard
has been turned over.
START OF CUT - Measure from the edge of the
matboard to the beginning of the cut say it measures
3.1cm (3 1/16") giving an undercut, adjust the Start of
Cut Adjuster (green pointer) so it reads what has been
measured - 3.1cm (3 1/16") by releasing the Start of Cut
Adjuster Screw and sliding the Adjuster.
Reset the Start of Cut Limit Stop to 3 in the normal way
using the large knob, the Start of Cut is now calibrated
for any size of mat made from that thickness of
matboard.
END OF CUT - Measure from the edge of the
matboard to the end of the cut say it measures 2.9cm (2
15/16") giving an overcut, adjust the End of Cut Adjuster
(red pointer) so it reads what has been measured -
2.9cm (2 15/16") by releasing the End of Cut Adjuster
Screw and sliding the Adjuster.
Reset the End of Cut Limit Stop to 3 in the normal way
using the wing bolt, the End of Cut is now calibrated for
any size of mat made from that thickness of matboard.
Start of Cut
Limit Stop
Green Pointer
Large Knob
Start of Cut
Adjuster Screw
Blue Pointer
End of Cut
Limit Stop
Wing Bolt
End of Cut
Adjuster Screw
Overcut
Undercut
End of Cut
Start of Cut
End of Cut
Start of Cut