KeepGuard KG780NV Instruction Manual - page 27
27
polarity. Always place the negative (lat) end of each battery in contact with the
spring side of its slot inside the camera.
3. After moving the switch from
″Off″ to ″Setup″ or ″On″, make sure that the
switch is correctly in position to ensure the proper mode (avoid
positions
″between″ two modes).
4. Do not move the switch directly from
″On″ to ″Setup″- always move the
switch all the way down to
″Off″ first, then back up to ″Setup.″
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Check the battery indicator icon to see if battery power is full. The flash will
stop operating near the end of the battery life.
b. You will get the best results when the subject is within the ideal flash range,
no farther than 45′ (14m) from the camera Subjects may appear too dark at
greater distances.
c. Please note that when the Capture Number parameter is set higher
than
″1 Photo″, or with very short Interval settings, some images may appear
darker than others due to the quick response and rapid retriggering of the
camera, allowing less time for the flash to fully recharge before firing again.
2. Daytime photos or videos appear too dark
a. Make sure that the camera is not aimed at the sun or other light sources
during the day, as this may cause the auto exposure to produce darker results.
3. Night photos or videos appear too bright
a. You will get the best results when the subject is within the ideal flash range,
no closer than 10′ (3m) from the camera. Subjects may appear too light at
closer distances.
4. Daytime photos or videos appear too bright
a. Make sure that the camera is not aimed at the sun or other light sources
during the day.
5. Photos with streaked subject
a. In some cases with low lighting conditions and fast moving subjects, the
5MP or 8MP resolution settings may not perform as well as the 3MP setting.
b. If you have multiple images where fast moving subjects produce streaks on
the photo, try the 3MP setting instead.
6. Red , green or blue color cast
a. Under certain lighting conditions, the sensor can become confused resulting
in poor color images.
b. If this is seen on a consistent basis, then the sensor may need servicing.
Please contact KeepGuard customer service.
7. Short video clips--not recording to the length set
a. Check to make sure that the SD card is not full.
b. Make sure that the camera has good batteries in it. Near the end of the
battery life, the camera may choose to record shorter video clips to conserve