Kelvinator KI420BFM2 User Manual - page 5
.1.
2.
3
4
5
6
It must be checked that the
used should be the same as the rated voltage
before the refrigerator is used.
voltage
The power plug should have its own separated socket in order to prevent the
electric wire from being over heated by other plugs.
Do Not allow children to tamper with the controls or play with the product.
Do Not hang heavy objects onto the door of the product to avoid the refrigerator
turning over..
It is dangerous to alter the specifications or attempt to modify this products
in any way
Do not place sealed container or carbonated liquids such as fizzy drinks into
the freezer as it creates pressure on the container which may cause it to explode
resulting in damage to the freezer or people.
Do not spray water on to the refrigerator. Otherwise it may cause malfunc
-tions of the refrigerator or electric shock.
Do not store flammable materials such as alcohol, gasoline, LP gas and glue
etc, in the refrigerator.
Ice cubes and ice lollies should not be consumed immediately after removal from
the freezer as it may result in low temperature skin abrasions.
When you change the light bulb or when the refrigerator is not in use for long
periods, disconnect it from the electricity supply..
Wait for 5 minutes before restarting the unit after the power supply has been stopped..
7.
8
9
10
11
When operating the refrigerator for the first time , set the thermostat dial at 3,
run it without loading any food. Usually this takes
2 or 3 hours. Then set the thermostat dial at the desired setting and place
foods into the refrigerator .
connect the electric wire and
Operation
Operation
1.
Cautions for Safety
Cautions for Safety
4
When making ice cubes , fill the ice tray with drinkable water. And put
it into the freezer . It takes about 2 or 3 hours to make ice cubes. Pieces of ice
cube can be removed by twisting it . Do not press it up and down , otherwise ,
the ice tray may break.
4.
Frost in the fridge will defrost automatically and the water can flow to the water
collection pan above the compressor. The water will evaporate by
the heat of
compressor.
Defrost the freezer whenever the layer of frost on the surface reaches 3 or 4 mm .
When defrosting , remove all foods , set the thermostat to position 0 and open the door.
After the frost has melted , discard the
water and dry up the interior of the freezer ,
The refrigerator can then be restarted by turning its thermostat to the desired setting .
5.
The temperature of the refrigerator can be adjusted by turning the thermostatic
dial. setting of the thermostatic dial at 3~4 is the most suitable for general
operation. The higher the thermostat dial is set,the lower the temperature inside
the fridge.
Do n t put too much food in the refrigerator .
Open the door less frequently in order to maintain the
temperature of the refrigerator and always leave
warm food to cool down to room temperature before
putting into the refrigerator to save electric consumption.
o
2.
3.
5
Do not heat the freezer directly with hot water or a hair dryer , This may cause
deformation of the inner casing .
6.
Do not scrape ice or separate food using a sharp tool or a wooden bar so as not to
damage the casing .
7.