Kempi KMS 400 AS Operating Manual - page 9
EN
pOsitiOning and lOCatiOn OF the MaChine
3.3
Place the machine on a firm, dry and level surface. Where possible, do not allow dust or other
impurities to enter the machines cooling air flow. Preferably site the machine above floor level;
for example on a suitable carriage unit.
Notes for positioning the machine
The surface inclination should not exceed 15 degrees.
•
Ensure the free circulation of the cooling air. There must be at least 20 cm of free space in
•
front of and behind the machine for cooling air to circulate.
Protect the machine against heavy rain and direct sunshine.
•
NOTE!
The machine should not be operated in the rain as the protection class of the machine,
IP23S, allows for outside preserving and storage only.
NOTE!
Never aim metallic grinding spray/sparks towards the equipment.
COnneCting CaBles
3.4
NOTE!
Always check before use that the interconnecting cable, shielding gas hose, earth return
lead/clamp, and mains cable is in a serviceable condition. Ensure that connectors are correctly
fastened. Lose connectors can impair welding performance and damage connectors.
water cooled system: FastMig KMs as + MsF/MXF + FastCool 10 + arcFeed
3.4.1
GND
7
FastM
ig KMS 400 AS / © Kemppi O
y / 1021