Kemppi FastMig X 450 Operating Manual - page 16
EN
4.3 Welding parameters
MIG
WFSpeed
0.7…25 m/min
Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed
and by 0.1, when WFSpeed > 5 m/min
WFS-Max
Sets the limit for maximum WFSpeed
WFS-Min
Sets the limit for minimum WFSpeed
Voltage
8…50 V
Step: 0.1
Controls the length of the arc
VoltageMax
Sets the limit for maximum voltage value
VoltageMin
Sets the limit for minimum voltage value
Dynamics
-9…+9
Factory setting is 0 Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher the
value the rougher the arc is.
1-MIG
WFSpeed
0.7…25 m/min *
Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed
min, and by 0.1, when WFSpeed > 5 m/min
WFS-Max
Sets the limit for maximum WFSpeed
WFS-Min
Sets the limit for minimum WFSpeed
FineTuning
-9…+9
Factory setting is 0
( = curve point)
Adjusts the arc voltage of the curve (arc length)
within certain limits
FineTuningMax -9…+9
Step: 0.5
Sets the limit for maximum arc length
FineTuningMin -9…+9
Step: 0.5
Sets the limit for minimum arc length
Dynamics
-9…+9
Factory setting is 0 Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher the
value the rougher the arc is.
PULSE MIG
WFSpeed
0.7…25 m/min *
Sets the wire feed speed.
Changes by steps of 0.05, when WFSpeed
5 m/min
WFS-Max
Sets the limit for maximum WFSpeed
WFS-Min
Sets the limit for minimum WFSpeed
FineTuning
-9…+9
Factory setting is 0
( = curve point)
Adjusts the base current of the curve (arc length) in
certain limits
FineTuningMax -9…+9
Step: 0.5
Sets the limit for maximum arc length
FineTuningMin -9 ... +9
Step: 0.5
Sets the limit for minimum arc length
Dynamics
-9…+9
Factory setting is 0 Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher the
value the rougher the arc is.
Pulse Current
-10…+15%
Factory setting
is 0 %
Reduces (–) or raises (+) the pulse current of the
curve
FastMig X 450
14