Microprojector instruction manual x-1000-1 trig.
2.
3 table of contents using the microprojector 4 setting up microprojector 4 revolving the dustproof disk 4 table projection 6 screen projection - direct projection 7 horizontal projection - using the mirror 8 to polarize light - using the microprojector as a polarizing microscope 9.
4 using the microprojector general notes: your microprojector is a very stable technology that has been available for many years but still incorporates many advances in the microprojection field. Uniquely, it will project an image either vertically or horizontally. For small groups or an individual,...
5 figure 1 figure 2.
6 figure 3. Labeled diagram of microprojector. Table projection: 1. Turn the switch to the "on" position. 2. Place a white sheet of paper between the legs of the base, or focus on a white or light colored surface. 3. Be sure the mirror is out of the way of the light beam coming straight through the ...
7 the desktop. First lower the stage to the lowest position, and then reverse direction until the specimen is brought into focus. 8. To gain an additional 5x magnification, rotate the revolving dustproof disk (5) until the red "a" is under the red line (7) on the upper disk. Again feel the revolving...
8 8. To gain an additional 5x magnification, rotate the revolving dustproof disk (5)until the red "a" is under the red line (7) on the upper disk. Again feel the revolving disk "click" into position. 9. In general, the higher the magnification, the darker the room needs to be. Note: sometimes it is ...
9 desktop. First lower the stage to the lowest position, and then reverse direction until the specimen is brought into focus. 8. To gain an additional 5x magnification, rotate the revolving dustproof disk (5) until the red "a" is under the red line (7) on the upper disk. Again feel the revolving dis...
1. Turn the switch to the "on" position. 2. Carefully rotate the entire head of the unit into a horizontal position. Do this by placing one hand on the base, just below the hinge joint to stabilize the base. Then position the head assembly with your other hand by pushing gently on the back of two me...
11.
5615 raytown road • kansas city, mo 64133 u.S.A. Tel.: 816-353-4787 • fax: 816-358-5072 email:info@ken-a-vision.Com • www.Ken-a-vision.Com ins-mp . Ken-a-vision reserves the right to make design improvements and other changes in accordance with the latest technology. There is no obligation to make c...
