Ken A Vision TRIG X-1000-1 Instruction Manual - page 9
9
desktop. First lower the stage to the lowest position, and then reverse
direction until the specimen is brought into focus.
8. To gain an additional 5X magnification, rotate the Revolving Dustproof
Disk (5) until the RED "A" is under the red line (7) on the upper disk.
Again feel the Revolving Disk "click" into position.
9. In general, the room needs to be darker when using the mirror to project
the image.
To Polarize Light - Using the Microprojector as a polarizing
microscope:
Figure 3.
1. Set up the microprojector in either the vertical or horizontal position as
noted above.
2. Move the Revolving Polarizing Analyzer (2) so that the polarized lens
(dark tinted) into the light path (located just below the light source).
3. Turn the Revolving Dustproof Disc (5) until the P (Polarizer) clicks into
place. This places the lower or second polarized lens in place.
4. Use the focusing knob (6) to focus image onto desk top.
5. Rotate the Analyzer lens located within the ring of the Revolving Polarizing
Analyzer (2) to change orientation of the polarized light. (Remember to
achieve polarization of light two polarizing lenses in the same optical
plane must rotate so that the lines of the lenses alternately move between
being parallel to each and perpendicular to each other).
Using Microprojector as a standard microscope -