Ken A Vision TRIG X-1000-1 Instruction Manual - page 6
6
Figure 3. Labeled diagram of Microprojector.
Table Projection:
1. Turn the switch to the "ON" position.
2. Place a white sheet of paper between the legs of the base, or focus on a
white or light colored surface.
3. Be sure the mirror is out of the way of the light beam coming straight
through the stage and going to the table surface.
4. Be sure that the Revolving Polarizing Analyzer (7) is out of the light path.
5. Rotate the Revolving Dustproof Disk (5) until the RED "C" on the left side
of the disk is directly under the RED line (7) on the upper disk. Feel the
Revolving Disk (5) "click" into position.
6. Place the specimen slide on the stage and hold in place with the stage
clips (3).
7. Focusing - Use the knurled focusing knob (6), located under the stage (3),
at the back of the unit behind the 16mm objective to focus image onto
1. Light Source
5. Revolving Dustproof Disc
2. Revolving Polarizer Analyzer
6. Knurled Focusing Knob
3. Stage with Stage Clips
7. Red Line
4. 16mm Objective Lens
8. Mirror
1
2
3
4
5
6
7
8