Kurzweil KSP8 IO OPTION - REV E Installation Manual - page 3
Using the KSP8 Analog I/O Option (KANA4)
3
Using the KSP8 Analog I/O Option (KANA4)
The Analog I/O Option adds four inputs and four outputs to your KSP8. The connectors are the same balanced
1/4" phone jacks that are used for the analog I/O on the stock KSP8, and their function is exactly the same. The
only difference you will see will be on the Config INSEL and INLVL pages:
•
The INSEL page will offer parameters Analog1 – Analog8 for each input.
•
The INLVL page will feature a second column for Inputs 5 – 8.
To confirm that the installation of the Analog I/O Option has been successful:
1. Press the
config
button.
2. Press the
INLVL
soft button. Two columns of inputs should be displayed, as shown below.
If only inputs 1 through 4 are displayed, the KSP8 is not recognizing the option. In this case, you
should confirm that the board is seated properly: turn off the KSP8, remove the board, then
reinsert it, making sure that it slides into both plastic rails and becomes seated in the connector at
the back of the opening.
Studio:INLVL|||||||||||I/O|Config=Studio
|||||
|||||||||||||||||||||||||||||||||||
In|1:
0.0dB|||||||||||||In|5:0.0dB|||||||
In|2:0.0dB|||||||||||||In|6:0.0dB|||||||
In|3:0.0dB|||||||||||||In|7:0.0dB|||||||
In|4:0.0dB|||||||||||||In|8:0.0dB|||||||
||||||||||||||||||||||||||||||||||||||||
INSEL||
INLVL|
INGRP||
BUSCFG|
OUTSEL|
OUTLVL