Kusam-meco KM 061 Operation Manual - page 10
-15-
ON
ON
Select
Inputs are made through the test leads terminals. Slide-switch ON
defaults at W
. Press SELECT button momentarily 3 times to select
Capacitance function.
Relative zero
mode can be used to zero out the parasitic
capacitance of the leads and the internal protection circuitry of the meter
when measuring low capacitance in the order of Pico Farad (pf).
r
-16-
Display Backlight (KM 062 only)
Press the SELECT button for 1 second or more to toggle the display
backlight on and off.
The Annunciator “ ” turns on. The meter also enters manual ranging
mode where available. The annunciator “
” turns off.
AUTO
The max feature compares and displays the measured maximum
value as fast as 30ms with auto-ranging capability. It allows the
meter to capture INRUSH currents in current functions. Press and hold
the MAX button for 1 second or more to toggle to the max feature.
The annunciators “MAX” and “ ” turn on.
H
H
The Hold feature freezes the display for later viewing. Press the
HOLD
button momentarily to toggle to the Hold feature. The
annunciator “ ” turns on.
H
H
When the meter is on, the Auto Power Off (APO) feature will switch the
meter into a sleep mode automatically to extend battery life after
approximately 30 minutes of no slide-switch nor push button operations
to extend battery life. To wake up the meter from APO, press any push
button momentarily or set the slide-switch to the OFF position and then
slide back on again. Always set the slide-switch to the OFF position
manually when the meter is not in use.