L-1 3100-1L User manual - page 17
Model 3100-1L Temperature Controller User Manual
14
ManualCommandsv1.vicomponents:
Stop Program Button
Stops the program and closes the program window.
Get/Set Toggle button
Toggle to Get to access the get commands and toggle to Set to access
the set commands, parameters and set accepted light. The get and set
commands are not simultaneously accessible.
Get Command
Allows selection of get commands from a drop down list. The Get/Set
toggle button must be toggled to Get for this drop down list to be
available. The get command is not sent to the temperature controller
until
the
Send button is pressed.
Get Commands are:
get_code_version
Code version (example: Temp Controller
PCB2024v1 Code1.1 April 2012; 117010254)
get_hsk_data
frame counter, 4 target temperatures in digital
numbers, 4 detector temperatures in degrees
Celsius, 4 Open Loop DAC setting values, 4 DAC
voltage
values
get_control_status
frame counter, 4 enable values, 4 mode type
values, 4 Open Loop DAC setting values, 4 target
temperatures in degrees Celsius, 4 error codes,
4 p terms of PID control, 4 i terms of PID control,
4 d terms of PID control, 4 kloop terms of PID
control
get_user_data
IP address, user net mask, user name, detector
type, 4 target temperatures in degrees Celsius,
4 p terms of PID control, 4 i terms of PID control,
4 d terms of PID control, 4 kloop terms of PID
control
Set Command
Allows selection of set commands from a drop down list. The Get/Set
toggle button must be toggled to Set for this drop down list to be
available. The set command is not sent to the temperature controller
until
the
Send button is pressed.