LA Fitness SA100 User Manual - Sa100 Assembly Instruction
STEP 3 : HANDLEBAR ASSEMBLY
FIG.4
4
SA100 ASSEMBLY INSTRUCTION
STEP 4 : PEDAL ASSEMBLY
STEP 5 : COMPLETE ASSEMBLY
1. Unscrews, pull out and hold the handlebar pulling knob (7).
Slide the handlebar post (6) all the way into the handlebar
tube. Release the handlebar pulling knob (7).
2. Adjust the handlebar (6) to make sure pulling knob (7) is
engaged. Tighten the handlebar pulling knob (7) securely.
(FIG.4)
Move the bike to the location where it will be used. Your spin
bike requires 120cm x 180cm of floor space for proper
operation. Rock the bike gently to check for wobble.
If needed, use the leveling adjusters under the front and rear
stabilizer bars to steady the bike. (FIG.6)
Note: The pedal spindles are marked “L” (left)
and “R” (right) to aid in assembly. Left and right
are referenced from a seated position on the
bike. Be sure to install the pedals on the correct
side of the bike.
1. Turn the resistance knob (15) all the way to the right until
crank arms are immobilized.
2. Install the left pedal (10) on the left pedal crank (11). Use
the multi wrench supplied and turn the left pedal (10)
spindle counterclockwise to tighten.
3. Install the right pedal (12) on the right pedal crank (13).
Use the multi wrench supplied and turn the right pedal (12)
spindle clockwise to tighten. Be sure both pedals are
tightened securely. (FIG.5)
6
7
12
14
14
11
10
FIG.5
FIG.6