La Marzocco SWIFT EPSB Manual - Warning
Fuse replacement and Reset Switches
The Swift EPS
B
has four fuses located at the rear of the
machine behind the removable panel. These
correspond to each of the grinder motors, the
tamping motor, and the electronic controls.
Occasionally it may be necessary to replace a fuse.
When switching fuses be sure to use only correctly
rated replacement fuses. Electronics = 1 ea. @ 125m
amps (normal); motor, grinder = 2 ea. @ 10 amps
GDC; motor, tamper = 1 ea. @ 1 amp GDC. On
machines with serial numbers 656 and higher, the
10 amp motor fuses are replaced with reset
switches on the exteror of the grinder. The head of
the switch will protrude when it needs to be reset.
Note: See page 31-32 for fuse sizes and locations.
26
English
Remove screws (2)
Pull out
La Marzocco International | USA • La Marzocco Technical Center s.r.l. | Italy
Pull down
(1) Disconnect the Swift EPS
B
from its power
supply.
(2) Access the fuse area by removing the two
screws located at the lower part of the rear
panel door. Do not remove the ground wire
screw on the rear panel door.
(3) Pull the panel door down and away, then
unplug the ground wire, to expose the control
electronics.
WARNING
HAZARDOUS VOLTAGE
DISCONNECT FROM
POWER SUPPLY BEFORE
SERVICING