La Spaziale S1 Mini Vivaldi II User Manual - S1 Mini Vivaldi II
S1 Mini Vivaldi II
Owner’s Manual
Page 10
portafilter handle, and press it with the included plastic tamper or, more optimally, a
high quality 53mm coffee tamper.
3. Fasten the portafilter handle (11) to the brewing group (10), placing a cup under the
portafilter handle.
4. By pressing the
Single Cup
button (24) the delivery starts and the lights 14-15-16
turn on to show that the one shot espresso dose is being programmed.
5. When the coffee inside the cup has reached the desired quantity, again press the
button (24) to stop the delivery.
6. You automatically return to the initial visualization.
7. Repeat the previous steps above using the
Double Cup
button (25) making sure
you change the filter inside the portafilter handle (11) to the double shot basket and
fill it with 14-16g of espresso first.
4.8 Hot Water Delivery
(only possible with the boiler turned on, BOILER light 13 on)
1. Place the pitcher below the hot water output (28):
2. Press the
Hot Water
delivery push-button (23).
3. The hot water delivery starts.
4. Once the desired quantity is reached, stop the delivery by pressing the
Hot Water
button (23) again.
Important Tip: The steam/hot water boiler on the V2 Mini is not very large. When
using it for hot water, it is suggested that no more than ~6oz be removed at a time
and then let the unit refill the boiler before using again. Otherwise, you run the
risk of exposing the steam boiler heater element while it is powered up and
possibly damaging it.
4.9 Steam Delivery
(only possible with the boiler turned on, light 13 turned on)
1. Insert the steam wand (2) in the pitcher containing the drink to be heated.
2. Push the steam lever (6) up, regulating the steam flow according to the need.
3. At the end of the heating phase of the drink, stop the steam delivery by pulling the
steam lever (6) all the way down.
4. Remove the pitcher from the steam wand (2) and wipe the steam wand and tip
immediately with a clean, damp sponge in order to remove all residue of the heated
drink.
5. NOTE: The steam lever (6) will remain in the all the way up position when released.
However, if released in any other position, the lever will automatically drop to the off
position.
Important Tip: Do not engage the steam lever (6) before placing the
steam wand (2) inside the pitcher, in order to avoid burns.