La Spaziale S1 Vivaldi II Owner's Manual - page 8
S1 Vivaldi II Owner’s Manual
Page 6
Tip the VII on its side. Twist all four rubber feet (3) hand tight as they may vibrate loose
during shipping. While performing that task, use a screwdriver to ensure that the four
screws on the bottom (two on each side between the rubber feet) which fasten the two
side panels (5) to the chassis bottom are tight. These steps will help ensure the
quietest possible operation of your VII.
Be sure you connect the included water hose to the threaded water inlet on the bottom
of the machine. Proper connection is obvious since there is only one place it can
attach. The opposite end of the hose - which connects to the water supply - may
require adapters from your local hardware store depending on your specific situation.
Contact your VII dealer for advice if the solution isn’t obvious. Also, your VII dealer may
request that you check that your water hardness is below a certain level to ensure long
life and trouble free operation. Hardness test strips may be included for this purpose. If
your water fails this test, contact your VII dealer and discuss the available options.
Once water supply is properly attached, turned on, and the desired basket has been
inserted into one of the portafilter handles, attach the portafilter to the group. Be sure
that the drip tray is installed by sliding it into place at the bottom front of the machine.
4.3 Turning On and Heating the Machine
1) Insert the plug into the 110V AC socket, the
On/STBY
light (22) starts flashing.
(Stand-by mode).
2) Press the
ON / OFF
(27) button and keep it pressed for about 3 seconds, the
green
On/STBY
light (22) changes from flashing to steady indicating the machine
is ON. At the same time the lights from (14) to (21) turn on steadily for about a
second (indicating power on test mode).