Labgear HDSR300 User Manual - page 5
4
1. Installation of STB
1.1 Front Panel
1. POWER Button
Turns the receiver On/Off
2. Display (4-digi 7-segment)
4-digi displays channel information; In Standby mode, 7-segment displays local time
3. USB2.0 Port
For PVR function, software updates, and other USB functions
1.2 Rear Panel
1. LNB IN
Connect the Satellite Dish LNB.
2. LOOP OUT
Output the Dish LNB IN signal.
3. AUDIO Right and Left
These connectors give you the possibility to connect the audio signal to an external
amplifier, or the audio input of your TV.
4. VIDEO
This connector has a composite CVBS video signal for additional VCR-connections.
5. TV SCART Connector
Use this connector to connect your receiver with your TV set using a SCART cable.
6. HDMI
Use this connector to connect your receiver with your TV set using a HDMI cable.
7. S/PDIF
Use this coaxial output to connect your receiver to the input of your digital audio amplifier.
8. Power ON/OFF Switch
9. Power Cord
Your receiver requires a current of 100~240V AC (Auto-selectable), 50~60Hz
+/-5%.