Labgear S601a User manual - page 14

14

S601a - Troubleshooting

For further information or any queries  

please contact

Technical Support:  

www.labgear.co.uk/support

Problem

Possible Causes

Solution

Display does not light 

up

Power switch is not on or battery power 

is low

Check to make sure meter power 

switch is on

Connect to charger/mains adaptor 

and make sure it is switched on

No sound or picture, but 

the front panel power 

light is ON.

AV IN cable connected, but no video 

input

Check AV IN cable connection, check 

AV source connection and signal

No sound or picture

The satellite dish is not pointing at the 

satellite.

Adjust the dish. Check the Signal Level 

in the Antenna Setup Menu

Bad picture/ 

Blocking Error

No signal or weak signal

Check the cable connections. LNB and 

other equipment connected between 

the LNB and the meter and adjust the 

dish.

The satellite dish in not pointing at the 

satellite

Adjust the dish

Signal is too strong

Connect a signal attenuator to the 

LNB input

Satellite dish is too small

Change to a larger dish

LNB noise factor is too high

Change to an LNB with lower noise 

factor

The LNB is faulty

Change the LNB

AV Out No picture 

(Video)

The system is connected by SCART 

cable and TV is not in AV mode.

Select rhe AV Input channel on the TV

The key is not working

Battery power is low

Connect to charger/mains adaptor

Keys are blocked

Adjust the position of the meter in the 

case or remove case