Labgear S601a User manual - page 8
8.2 DVB-T2
In the Main Menu select DVB-T2, Press OK to enter Scan Setup.
Scroll down to adjust the settings below:
8.2.1 Country Setting
Use the t u keys to select country.
8.2.2 Channel No.
Use the t u keys to change channel number.
8.2.3 Frequency
Use the number keys to enter frequency.
8.2.4 Bandwidth
Use the t u keys to change the bandwidth, you can select
5, 6, 7 or 8M
8.2.5 Mode
Use the t u keys change the DVB standard you can select
T/T2/T+T2.
8.2.6 Beep Tone
Use the t u keys to turn the beep tone on or off. If switched
on you will hear the tone when you enter the search screen.
8.2.7 Antenna Power Setting
This is only applicable to terrestrial aerials with built in or
masthead amplifiers. Use the u key to set the required
voltage: 5V/12V/24V.
8.2.8 Antenna Power Setting
If aerial amplifier present use the u key to select power On.
8.2.9 Quick Search
When you have completed the above settings. Press OK to
enter the Scan Setup Menu.
• Manual Scan - Press OK again or the Red TTXT key to start a
manual earch of the current channel.
• Auto Scan: Press the Green SUBT key to auto search the
current channel.
Please Note: The following prompt will appear
“Database willl be cleared! Continue?” If you are sure you
want to go ahead press OK.
• S/Q: Press the Orange key to enlarge signal strength and
quality readings.
S601a - Program Info - Multimedia
8