Lakeair LA-1400S Operating And Service Instructions - page 8
c)
High Pressure Steam Cleaner – Car Sprayer Method
1.
Saturate Cells
2.
Spray on liquid detergent or cleaning solution marked
“Safe for Aluminum“.
3.
Wa sh.
4.
Rinse with hot water.
5.
Allow cell to air dry thoroughly.
Inspect cells. If any dirt remains, repeat cleaning procedure. If it is necessary to repeat the cleaning procedure, it is
advisable to increase the washing frequency.
Check cells for bent plates and broken ionizing wires. Reinsert cells and carbon filters. DO NOT INSERT CELLS if not
completely dry.
Approximately every 6 months place a drop of oil in the two oil holes on the fan motor. Use non-detergent electric motor
oil only. (SAE 20).
V.
REPAIR AND MAINTENANCE
A.
OWNER’S CHECKLIST & RETURN PROCEDURE.
Before attempting any repairs on your Electronic Air Cleaner, check the following items
first.
1.
Ch ec
fu
k se.
2.
Check for electrical power to unit.
3.
Check that the electronic cell, prefilter screen and carbon filter are
“CLEAN”, dry and properly installed in the Air
Cleaner.
Repair work should only be performed by a trained, experienced serviceman. Check with your dealer for the repair
station in your area. If unable to locate a qualified serviceman, contact the factory at the address or telephone number
listed below for authorization to return the unit to the factory. DO NOT RETURN UNIT TO FACTORY WITHOUT
AUTHORIZATION.
RK Ventures Inc. / LakeAir
1509
RA PIDS
DRI VE
RACI
W
NE, I 5340 4
1-800-558-9436
FAX 262- 632-3144
Web site: www.lakeair.com
Page 8