Lambo Doors Canada Chevrolet Camaro 1993 Instructions Manual - page 6
6) Preparation for factory hinge
removal:
Close the door and use painter’s
tape to secure the door to the
body, in preparation for factory
hinge removal.
Use a 13mm wrench to remove
the (4) bolts securing the factory
hinges to the apron and a 15mm
wrench to remove the (4) bolts
securing the factory hinges to the door.
Insert spacers after removing the factory hinges.
Hint*(You can make your spacers out of paint sticks and about 8-10 turns of
blue painters tape)
Hint* Use painter’s tape to protect the edges of the fenders and the doors.
7) Install your new Vertical Doors Inc. system:
Make sure the VDI sits flat against the apron.
Use a 15mm wrench to secure the VDI
system to the door and a 14mm Wrench to
secure the VDI system to the apron.
Cut the factory wire boot in half. The half that
is going to the door will be removed and
aftermarket wire look will be added to protect
exposed wires.
Hint* Tighten the bolts on the door first then
the bolts on the apron.