Lambo Doors Canada Chevrolet Camaro 1993 Instructions Manual - page 8
of
11
2
3
1
8) Once hinge is locked in place, break nut #1 then turn Allen set
screw #2 on fig until it hits the block then open the door and continue
to adjust until the door matches with the striker, open and close door
making sure it closes like factory.
Hint*(leave #1 nut loose until shock is installed Allen set screw will
have to be re-adjusted after shock is installed.
9) Install the shock.
Hint* (You will need a helper to raise the door). (Slip the spherical rod
mount into the spherical ball bearing (1). Using a 1/4 Allen wrench,
tighten the screw into the swing arm (2). After the shock is installed
secure it by installing the pin in the bottom shock end (3).
SCREW #2
NUT #1
BODY OF
CAR
DOOR