Lance ADX-2400M Installation And Operation Manual - page 15
15
There is no DELAY available in the Announce Booth mode.
To Adjust Headphone Volume
Press the 'HP VOLUME' button, and turn the knob. The bar graph display will show
the knob 'position'.
To Configure Menu Items
The system has several configuration items which may be set by using the menu
function. Press the 'MENU SELECT' button to enable the menu function. Turn the
knob to select the desired menu item, then press the 'MENU SET' button. Turning
the knob will now change the parameter for this item. When the desired selection is
made, you can exit the MENU SET mode by pressing any other button. (See
section on menu items below).
MENU ITEMS - ANNOUNCE BOOTH MODE
Item 01 – REMOTE DEVICE A ID = (00-99)
This item selects which physical remote device will appear as device A in the ADX-
2400. The mic outputs of the selected device will appear as Mic A1 and A2, the
IFBs will appear as IFB A1 and IFB A2, etc.
The number selected corresponds to the System ID set on the rotary switches of the
remote device. 01 through 99 are valid IDs. 00 is off, and selects no remote device
for Unit A.
Item 02 – REMOTE DEVICE B ID = (00-99)
Item 03 – REMOTE DEVICE C ID = (00-99)
Item 04 – REMOTE DEVICE D ID = (00-99)
Same as above for devices B, C, and D. Note that each remote device on the
network must have a unique ID number, and that a given remote device should only
be assigned once; in other words don't assign the same unit to be both Unit A and
Unit B.
Item 05 - Madi Channel Range (1-24, 33-56)
This item selects the madi channels which will be seen as inputs to the ADX-2400M,
and the madi channels which will be output by the ADX-2400M. All other madi
channels in the input stream will be passed through the unit to the output stream
unaltered.
Item 6 - Madi Input (Coax, Optical)
Selects which physical madi input will be enabled. Both optical and coax outputs are
always active regardless of this menu setting.