Lance ADX-2400M Installation And Operation Manual - page 6
6
QUICK OPERATION GUIDE - NORMAL MODE
To Select Output Channel (or Channels) to Adjust
Press ‘OUTPUT SELECT’ button, and turn knob until desired channel is selected.
Repeated presses of the 'OUTPUT SELECT' button will advance the selection to the
first channel of the next group of eight individual channels, or to the next group
selection. The order of the channel selection is as follows:
Madi Output 1 through 24 (Individual Outputs)
Madi Outputs 1-8 (Group)
Madi Outputs 9-16 (Group)
Madi Outputs 17-24 (Group)
All Madi Outputs (Group)
Net (Transmitted to Ethernet) Output 1 through 24 (Individual Outputs)
Net Outputs 1-8 (Group)
Net Outputs 9-16 (Group)
Net Outputs 17-24 (Group)
All Net Outputs (Group)
If the high madi channel range is selected in the menu, the madi channels will
be 33-56 instead of 1-24, and the display will change accordingly.
Note that if a group of outputs is selected, any setup adjustments (source, level,
delay) will be applied to all output channels within that group.
To Select Source (for current output or group of outputs)
Press 'SOURCE' button. It will light, and the currently-selected source for the
selected output will be displayed. The sources available for each output are as
follows, and can be selected by turning the knob.
SILENCE
The output will be muted
MADI INPUT
The output will be fed by the corresponding Madi input
NET INPUT
The output will be fed by the corresponding network receiver
888HZ TONE
The output will be fed by the internal 888 Hz tone generator
560 HZ TONE
The output will be fed by the internal 560 Hz tone generator
You may enable a ‘stereo summing’ mode by selecting any of the following choices,
which follow the above sources in the menu list. In these modes, the selected
source will be combined with the selected source for the other channel in the
even/odd pair; e.g., channels 1 and 2, channels 3 and 4, etc. When a ‘something +
mix’ source is selected, the mixed signal is reduced by 6 dB.
SILENCE + MIX
The output will be silence and the other channel mixed
MADI INPUT + MIX The Madi input mixed with the other channel of the pair
NET INPUT + MIX
The network receiver mixed with the other channel of the pair
888HZ TONE + MIX 888Hz tone mixed with the other channel of the pair
560 HZ TONE +MIX 560Hz tone mixed with the other channel of the pair