Lancia Ypsilon Owner's Handbook Manual - page 26

25

SAFETY

DEVICES

CORRECT

USE OF 

THE CAR

WARNING

LIGHTS AND

MESSAGES

IN AN

EMERGENCY

CAR

MAINTENANCE

TECHNICAL

SPECIFICATIONS

INDEX

DASHBOARD

AND CONTROLS

Instrument panel and sound

system/automatic climate control

light dimmer (Light.) 

(only with sidelights on)

With this function it is possible to ad-

just on 8 levels (with sidelights on) the

light intensity of the instrument panel,

sound system controls and automatic

climate control (where provided) con-

trols.

To adjust the light intensity level re-

quired, proceed as follows:

– briefly press button MODE the pre-

viously set level will flash on the dis-

play;

– press button 

ö or õ to select the re-

quired level;

– briefly press button MODE to go

back to the menu screen or press the

button for long to go back to the stan-

dard screen without storing settings.

Speed limit (Speed lim.)

With this function it is possible to set

the car speed limit (km/h or mph);

when this limit is exceeded the driver

is immediately alerted (see section

“Warning lights and messages”).

To set the speed limit, proceed as fol-

lows:

– briefly press button MODE, the dis-

play will show the wording (Speed

lim.);

– press button 

ö or õ to select speed

limit activation (On) or deactivation

(Off);

– after pressing (On), press button 

ö

or õ to select the required speed limit

value and then press MODE to con-

firm.

Note The possible setting is between

30 and 250 km/h, or between 20 and

155 mph depending on the unit set

previously (see “Distance unit (Dist.

unit)” paragraph described later.

Every press on button 

ö / õ in-

creases/decreases by 5 units. Keeping

the button 

ö / õ pressed obtains the

fast automatic increase or decrease.

When you are near the required set-

ting complete adjustment by single

presses.

briefly press button MODE to go back

to the menu screen or press the but-

ton for long to go back to the stan-

dard screen without storing settings.

To abort the setting, proceed as fol-

lows:

– briefly press button MODE, (On)

will flash on the display;

– press button õ, (Off) will flash on

the display; 

– briefly press button MODE to go

back to the menu screen or press the

button for long to go back to the stan-

dard screen without storing settings.

Automatic headlight daylight

sensor (Light sensor)

(where provided)

With this function it is possible to ad-

just the light sensor sensitivity ac-

cording to 3 levels (level 1 = min.

level, level 2 = average level, level 3 =

max. level); the higher the sensitivity

is, the lower is the external light in-

tensity required to switch on the

lights. The car is delivered with sen-

sitivity level “2”.

To set the light level required, proceed

as follows:

– briefly press button MODE, the pre-

viously set level will flash on the dis-

play;

– press button 

ö or õ to select the re-

quired level;

– briefly press button MODE to go

back to the menu screen or press the

button for long to go back to the stan-

dard screen without storing settings.

001-034 Ypsilon GB  10-10-2008  10:17  Pagina 25