Lancom GS-2310P Instruction Manual - 5.1.1
Installation Guide LANCOM GS
-
2310P/GS
-
2326(P)/GS
-
2352(P)
K
Chapter 5: Configuring and monitoring the LANCOM switch
21
EN
K
With LANmonitor you can use a Windows computer to monitor all of your
LANCOM devices. This program displays all important status information
5.1.1
Starting WEBconfig
There are two ways of starting the configuration by browser:
K
If you know the device's IP address, simply enter this into the address line
in the browser. The factory settings for accessing the device are: User
name "admin", password "admin".
K
If you do not have the device's IP number, LANconfig can be used to
search for it. To start LANconfig click on Start / Programs / LANCOM / LAN-
config. LANconfig automatically searches for all available devices in your
network. Any available LANCOM routers or access points will be displayed
in the list, including the LANCOM switch. Double-click on this entry to
start the browser automatically with the correct IP address..
What is the IP address of my LANCOM switch?
The current IP address of the LANCOM switch after being switched on
depends on the network constellation.
K
Networks with DHCP server – In its factory settings, the LANCOM switch
is set for auto DHCP mode, meaning that it searches for a DHCP server to
assign it an IP address, subnet mask and gateway address. The assigned
IP address can only be determined by using the appropriate tools (e.g.
LANconfig) or via the DHCP server. If the DHCP server is a LANCOM device,
the IP address of the LANCOM switch can be read out from the DHCP
table. If this is the case, the LANCOM switch can be accessed from any
network computer that receives its IP address from the same DHCP server.