1. DL manuals
  2. Landmann
  3. Patio Heater
  4. 12016
  5. Assembly And Operating Instructions Manual

Landmann 12016 Assembly And Operating Instructions Manual

Summary of 12016

  • Page 1

    V ersion : 12016 uk r evision : #100-2010 e dition : 12/09 cd assembly and operating in- structions for patio heater, item no. 12016 please read before starting! Failure to observe these instructions can affect or damage the device and other objects and lead to personal injury. We therefore recommen...

  • Page 2: Table of Contents

    2 landmann table of contents technical specifications ............................................................................................................ 3 delivery specifications .............................................................................................................. ...

  • Page 3: Technical Specifications

    3 landmann technical specifications approvals its test number - 0359 pin no. 359bu1020 heater appliance category i 3+ according to din en 14543 total weight approx. 15.5 kg dimensions (Ø x h) approx. 76 x 220 mm gas system heat output approx. 14 kw mass flow rate 1018 g/h burning time approx. 1 h/kg...

  • Page 4: Delivery Specifications

    4 landmann delivery specifications pos. Qty. Description pos. Qty. Description 1 1 base a 6 m6x15 2 1 cylinder chamber support b 3 m6 3 1 connection for cylinder cham- ber support c 6 Ø20xØ6,5x1,0 4 1 rubber attachment d 9 m6x15 5 1 lower column (long) e 15 m6 6 1 connection f 9 m5x15 7 1 upper colu...

  • Page 5

    5 landmann a b c d e f g h i.

  • Page 6: Exploded View

    6 landmann exploded view.

  • Page 7: Controls

    7 landmann controls pos. Designation function a piezo igniter ignite gas on burner (press). B flame regulator fill burner with gas to ignite (keep depressed and turn to "large flame" setting). After ignition adjust the heat input for the left burner (turn). G1 pressure reducer reduce gas pressure. G...

  • Page 8: Utilisation

    8 landmann utilisation correct utilisation this heater is a gas-powered heater for use outdoors or in well-ventilated areas. It is designed to be used exclusively for heating purposes outdoors or in well-ventilated areas and in accordance with all of the details in this instruction manual. For priva...

  • Page 9: Safety Precautions

    9 landmann safety precautions definition of terms used the following pictograms and signal words are used in these instructions to point out hazards and important information: safety precautions pictogram and signal word note on ... Danger ... A possible danger that can result in severe personal in-...

  • Page 10: Possible Consequences:

    10 landmann danger "hot surfaces and parts" during operation some parts of the heater can become very hot, particularly those that are close to the burner. Possible consequences: • severe burns if parts near the burner are touched. • fire or smouldering fire if flammable materials or substances are ...

  • Page 11: Possible Consequences:

    11 landmann danger "gas is highly flammable" liquid gas is highly flammable and explosive. Possible consequences: • serious personal injury or damage to property if escaping gas ignites in an environment in which it is not controlled. Safety measures: • only operate the heater outdoors or in well-ve...

  • Page 12: Possible Consequences:

    12 landmann danger "gas displaces oxygen" liquid gas is heavier than oxygen. Therefore, it settles on the ground, displa- cing the oxygen at that level. Possible consequences: • suffocation resulting from a lack of oxygen if the gas concentration is allowed to rise sufficiently. Safety measures: • d...

  • Page 13: Assembly

    13 landmann assembly before you start here are a few tips to help you assemble your heater quickly and successfully: • check that no parts are missing by placing all of the individual parts on an empty table (we reserve the right to make minor technical alterations, such as the content of the small ...

  • Page 14: Assembly Procedure

    14 landmann assembly procedure 1. Assemble the cylinder chamber supports (2) to the base (1) using m6x15 (d) bolts and m6 (e) nuts. 2. Screw the connecting element (3) to the cylinder chamber supports (2) using m6x15 (a) bolts and m6 (e) nuts. 3. Slide the rubber attachment (4) over the underside of...

  • Page 15

    15 landmann 4. Place the connecting ring (6) onto the lower column (long) (5). Now slide the upper column (short) (7) onto the lower column (long) (5) until the three holes overlap. Secure the column (long and short) (5 +7) using m5x15 (f) bolts. 5. Slide the cylinder chamber (8) over the column (lo...

  • Page 16

    16 landmann 6. Screw the connections for the reflector (13) to individual reflector units (12) using m4x15 (g) bolts, Ø4.3 (i) washers and m4 (h) nuts. 7. First place the reflector and the connecting ring (14) onto the threaded rods of the burner (11). Secure the reflector (12) in place using Ø 6.5 ...

  • Page 17

    17 landmann 9. To connect a gas cylinder slide the cylinder chamber (8) upwards, connect the cylinder and position it between the cylinder chamber supports (3). Then lower the cylin- der chamber (8) over the gas cylinder until it comes into contact with the base (1). 10. Assembled gas patio heater. ...

  • Page 18: Parts and Tools Needed

    18 landmann connecting and disconnecting the gas cylinder parts and tools needed • 17 mm spanner (open-ended spanner sw 17) • gas cylinder standard camping gas cylinder with 5 or 11 kg liquid gas (e.G. Grey camping propane gas cylinder). These are available at diy shops or liquid gas suppliers. Leak...

  • Page 19: Shut Off Gas Cylinder

    19 landmann g5 g1 g3 9 g2 g4 2. Position the gas cylinder next to the heater. – never lay the gas cylinder on its side or place it on the base shelf. – the gas hose must not be bent or un- der tension. 3. Check that the gas cylinder (g3) and the pressure reducer (g1) are in good working order. 4. Tu...

  • Page 20: Operation

    20 landmann operation starting up the burner before using, wash the roasting tray (2) thoroughly with warm soapy water and allow both to dry well. Then apply cooking oil to the top side of both parts. This will prevent the cooked food from sticking to the roasting tray. 1. Check to ensure that .... ...

  • Page 21: Switching Off The Heater

    21 landmann switching off the heater 1. Close the cylinder valve on the gas cylinder (turn g1 clockwise). 2. Turn the flame regulator (b) with the small flame symbol to "•" (off). 3. Wait until all of the parts have cooled down and then clean any soiled components. 4. If the heater is not going to b...

  • Page 22: Troubleshooting

    22 landmann troubleshooting if there is a fault despite due care, this chapter may help you to resolve the malfunction. Malfunction cause remedy there is a smell of gas leak in the gas system 1. Close the cylinder valve im- mediately (turn g1 clockwise) 2. Prevent any flame or spark formation (do no...

  • Page 23: Declaration of Conformity

    23 landmann declaration of conformity.

  • Page 24

    24 landmann landmann® ltd. Unit 1, ryelands business centre, ryelands lane, elmley lovett, worcs, wr9 0pt, united kingdom e-mail: enquiries@landmann.Co.Uk, internet: www.Landmann.Co.Uk hotline barbecue helpline **44 - 12 99 - 25 17 47, sales office fax: **44 - 12 99 - 25 11 34 monday to thursday 9am...