Landmann 12016 Assembly And Operating Instructions Manual - Assembly
13
Landmann
Assembly
Before you start
Here are a few tips to help you assemble your heater quickly and successfully:
• Check that no parts are missing by placing all of the individual parts on an empty table (we reserve
the right to make minor technical alterations, such as the content of the small parts bag).
• If, despite careful factory checks, a component is missing, please contact our customer service
department (see the last page). We will then immediately attend to your request.
Sort out the small parts, as some of the bolts, for example, are very similar and can be easily
confused.
• For assembly you will need a medium size screwdriver and a suitable spanner (flat spanner or box
spanner).
• You will need a flat spanner (AF17) to connect the gas cylinder.
Only use tools that are intact and suitable for the job at hand. Worn or unsuitable tools will not allow
you to tighten the bolts sufficiently, but will damage them to the extent that they can no longer be
turned.
• Always attach all connecting elements (bolts, nuts, etc) as shown in the following illustrations. If
you misplace a connecting element, replace this with an appropriate part. Only by doing this can
you ensure that the construction is strong and safe.
• It is essential that you follow the instructions in the order they are specified!
• Read the text for each step before carrying it out, as useful information is sometimes only provided
at the end of the section.
•
Even if you are not experienced at DIY, assembly does not generally take more than one hour.