Laney Nexus User Manual - Rack Mounting
20
Rack Mounting
Ventilation:
Ensure the amplifier is well ventilated and that the ventilation slots in the top, bottom & sides are not obstructed in any way.
Avoid dropping anything in through the vents especially liquids of any kind. If this should happen turn off the product and disconnect from
the power supply immediately and leave to dry out for at least 24hrs. Seek help from a qualified service engineer.
Rack Mounting:
Using the included Rack Wings, the chassis may be fitted into a standard 2U sized slot in a 19” rack unit. The wings are provided with a
choice of mounting holes to allow the fascia to be flush with or recessed into the rack mounts. Only use the supplied mounting screws to
attach the wings to the amplifier, as longer items could cause internal damage.
Ventilation must also be considered when rack mounting and adequate provisions made. We recommend that a gap no less than a 1U slot
is provided on top and underneath the amplifier to provide adequate air flow for cooling.
Rack Wing 008496
M4 x 10mm Screw 008497
1U
1U
Choice of
mounting positions