Lang 36S-20M-U Installation, Operation, Maintenance, & Troubleshooting - Maintenance & Cleaning
16
MAINTENANCE & CLEANING
WARNING
MAKE SURE THE RANGE HAS BEEN PROPERLY SECURED
FROM POWER BEFORE REMOVING ANY COMPONENTS.
REMOVAL INSTRUCTIONS
OVEN
Thermostat and 3-Switch
These parts are located behind the control panel assembly on the right hand side of the oven. To access
control panel, remove the vent knob and the seven screws around the outside of the control panel assembly.
Slowly pull the control panel toward you until the component is accessible.
Thermostat
Inside the oven, remove the retaining clips holding the thermostat capillary tube to the inside of the oven.
Feed the bulb through the oven wall into the control panel area. Pull out control panel as previously
outlined. Remove knob and two screws that hold the thermostat to the oven control panel. Remove the wires
from the old thermostat and attach to the corresponding terminal of the new thermostat. Discard old
thermostat. Reinstall the thermostat and capillary tube into oven and the control panel and restore power to
the oven. Test for proper operation.
3-Switch
Pull out control panel as previously outlined. Remove the wires from the 3-heat switch being changed.
Place those wires on the corresponding terminal 3-heat switch. Remove old 3-heat switch and mount new 3-
heat switch with wires attached. Discard old 3-heat switch. Reinstall the control panel and restore power to
the oven. Test for proper operation.
Elements
Remove oven rack. Bend tab on element clip using a pair of pliers so that the element may be removed.
Gently pull elements down and to the left away from the right hand side of oven. Noting wire locations,
disconnect wires from element. Discard old element. Reverse removal instructions to install. For bottom
element removal it will be necessary to remove the bottom deck before removing elements. Removing the
two screws on either side of the deck does this.
RANGE TOP
6-Heat Switch
Remove two sheet metal screws holding control panel to range top and remove control panel. Remove the
6-heat switch knob and two screws holding the 6-heat switch to the control panel. Remove wires from the 6-
heat switch terminals noting the wire locations. Discard old 6-heat switch. Reverse removal instructions.
French Plate
Using two 9” braces, lift the French Plate frame assembly up and secure with the two 9” braces. Remove
wires from the element terminals, noting the wire locations. Remove defective French Plate assembly from
the range. To install reverse removal instructions.