Lang PBE12 Installation Operation & Maintenance - Operation
Rev. - 2006
11
OPERATION
Control Panel
SET TEMP
Display
TIME
READY
MODE
UP
DOWN
START /
RESET
Time & Set Temp Lights
Either light will illuminate to indicate which mode has been accessed (see Mode Button instructions).
Ready Light
This light will illuminate when the Actual Temp reaches the Set Temp.
Display
Time or Set Temp will bedisplayed, corresponding with the mode that has been selected (see Mode
Button instructions). The Actual Temp can also be displayed (see the Additional Features section).
NOTE: The Display will flash when the Actual Temp is adjusting to the Set Temp. Once the Actual
Temp reaches the Set Temp, the display will revert to steady on, the Ready Light will illuminate and
an alerting buzzer will sound.
Mode Button
Use this to change from Time Mode to Set Temp Mode and back again. NOTE: The Pane Bella may
be configured to display either one or four timers (see Additional Features section).
Up & Down Buttons
Use to adjust the Time and Set Temp. Pressing and holding either button will activate the scroll
feature. Holding the buttons down longer will result in a faster scroll rate.
Start/Reset Button:
Press once to start timer count-down. Once count-down is complete, a buzzer alert will sound. Press
the Start/Reset Button again to silence the buzzer and reset the timer. NOTE: Pressing the Start/Reset
Button at any point during a count-down will reset the timer.
Additional Features
• All settings will be saved when the Pane Bella is turned off and will be automatically recalled
when the power is turned back on.
• To convert from a single timer to four timers and back again, simultaneously press and hold Mode
and Down Buttons for 5 seconds.
• The Actual Temp may be viewed at any time by simultaneously pressing the Mode and Up
Buttons.
• Temperatures may be displayed in
o
F (factory default) or
o
C. To convert from one to the other,
simultaneously press the Up and Down Buttons while turning the power switch on.
• PBE24 Only: One or both toasters may be used by setting the rocker switch to the desired
position.