Lang PBE12 Installation Operation & Maintenance - Unpacking

Summary of PBE12

  • Page 1

    Star manufacturing international 10 sunnen drive st. Louis, mo 63143 part number: 2m-z9993 phone: (314) 781-2777, fax: (314) 781-2714 rev. C www.Star-mfg.Com october 23, 2007 . Installation, operation & maintenance model: pbe12 & pbe24.

  • Page 2

    2 these symbols are intended to alert the user to the presence of important operating and maintenance instructions in the manual accompanying the appliance. Retain this manual for future reference notice using any part other than genuine star factory supplied parts relieves the manufacturer of all l...

  • Page 3: Table of Contents

    Rev. - 2006 3 table of contents chapter page read first......................................................................................................4 equipment description ..........................................................................6 unpacking.....................................

  • Page 4

    Rev. - 2006 4 important read first important caution: the griddle pbe12 weighs 70 lbs (32 kg). The pbe24 weighs 130 lbs (59 kg). For safe handling, installer should obtain help as needed or employ appropriate materials- handling equipment (such as a forklift, dolly or pallet jack) to remove the unit...

  • Page 5

    Rev. - 2006 5 important read first important warning: keep water and solutions out of controls. Never spray or hose control console, electrical connections, etc. Caution: most cleaners are harmful to the skin, eyes, mucous membranes and clothing. Precautions should be taken to wear rubber gloves, go...

  • Page 6: Equipment Description

    Rev. - 2006 6 equipment description pane bella, single grill (pbe12) • power: the pbe12 operates on 120, 208 or 240 volts. Each grill is supplied with the appropriate cord and plug built in. • counter space required: 13.3 in wide (33.7 cm) and 14.0 in deep (35.6 cm). • weight: the grill weighs 70 lb...

  • Page 7: Unpacking

    Rev. - 2006 7 unpacking receiving the griddle upon receipt, check for freight damage, both visible and concealed. Visible damage should be noted on the freight bill at the time of delivery and signed by the carrier's agent. Concealed loss or damage means loss or damage which does not become apparent...

  • Page 8: Installation

    Rev. - 2006 8 installation danger: this appliance must be grounded at the terminal provided. Failure to ground the appliance could result in electrocution and death. Warning: installation of the unit must be done by personnel qualified to work with electricity. Improper installation can cause injury...

  • Page 9: Installation Cont’D

    Rev. - 2006 9 installation cont’d ventilation and clearances standard minimum clearance from combustible construction is as follows: 1 inches from sides 4 inches from back 1 inches from floor the installation of any components such as a vent hood, grease extractors and/or fire extinguisher systems m...

  • Page 10: Initial Start Up

    Rev. - 2006 10 initial start up initial start up before starting the grill for the first time, clean the grill body and cooking surfaces with a mild soap and water solution, then rinse with clear water and dry. Close the upper cooking surface and set the temperature to 200°f (93°c) for two hours to ...

  • Page 11: Operation

    Rev. - 2006 11 operation control panel set temp display time ready mode up down start / reset time & set temp lights either light will illuminate to indicate which mode has been accessed (see mode button instructions). Ready light this light will illuminate when the actual temp reaches the set temp....

  • Page 12: Operation Cont’D

    Rev. - 2006 12 operation cont’d setting the temperature caution: always keep the area near the appliance free from combustible materials. Caution: keep the floor in front of the equipment clean and dry. If spills occur, clean immediately to avoid the danger of slips or falls. A single control panel ...

  • Page 13: Cleaning & Maintenance

    Rev. - 2006 13 cleaning & maintenance cleaning warning: keep water and solutions out of controls. Never spray or hose control console, electrical connections, etc. Caution: most cleaners are harmful to the skin, eyes, mucous membranes and clothing. Precautions should be taken to wear rubber gloves, ...

  • Page 14

    2 12 41 22 10 11 6 1 4 5 16 7 9 13 3 8 23 21 17 14 15 29 18 20 27 42 26 24 24 19 25 34 33 36 37 28 20 38 35 32 30 39 40 certain instances may not be available illustrative purposes only and in some items are included for model: pbe12 sk2222 rev. B 12/5/2007 no reproduction or disclosure of its to la...

  • Page 15: Parts List

    Parts list december 5, 2007, rev. C important: when ordering, specify voltage or type gas desired page include model and serial number of some items are included for illustrative purposes only and in certain instances may not be available. Number per unit description star manufacturing international...

  • Page 16

    18 19 20 20 7 8 5 6 7 1 25 26 21 10 22 4 16 38 13 42 15 15 9 9 3 23 13 31 30 28 37 27 36 24 26 39 35 17 14 2 33 34 32 29 45 12 11 41 40 40 43 44 certain instances may not be available illustrative purposes only and in some items are included for model: pbe24 sk2223 rev. A 10/23/2007 no reproduction ...

  • Page 17: Parts List

    1 2n-11030-40 2 ele grdpani208/240v900w pbe24g, pb, gs, s 2 2n-11030-41 2 elegrdpani208/240v720w pbe24g, pb, gs, s 3 2e-30303-28 1 swt rocker on-off-on pbe24g, pb, gs, s 4 2t-30401-31 2 stat fxd 400 deg open pbe24g, pb, gs, s 5 2e-30500-03 1 trm strp 6 pole 30a 300v pbe24g, pb, gs, s 6 2e-30600-04 1...

  • Page 20

    Star manufacturing 10 sunnen drive, st. Louis, mo 63143 u.S.A. (800) 807-9054 (314) 781-2777 parts & service (800) 807-9054 www.Star-mfg.Com.