Lantronix UDS1100 Quick Start Manual

Other manuals for UDS1100: User Manual, User Manual

Summary of UDS1100

  • Page 1

    2006 copyright © lantronix is a trademark of lantronix. All rights reserved. 900-418 rev. A 02/06 uds1100 quick start guide uds1100

  • Page 2

    Uds1100 quick start contents what’s in the box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 pinouts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 ip ad...

  • Page 3

    Q u i c k s t a r t g u i d e u d s 1 1 0 0 the uds products allow serial devices to connect and communicate over an ethernet network. This quick start explains how to connect, configure, and troubleshoot your unit using a network connection and our deviceinstaller software. For more detailed inform...

  • Page 4

    4 w w w . L a n t r o n i x . C o m connect complete the following steps in order. Refer to the numbers in the figure below. 1. Connect a serial device to your unit. 2. Connect an ethernet cable to the rj45 port. 3. Supply power to your unit using the power supply that was included in the packaging....

  • Page 5

    Assign ip address continued… 3. Enter the hardware or ethernet address of the device. The address is on the label on the underside of the unit. 4. Select assign a specific ip address to assign a static ip address to the device, or select obtain an ip address automatically to enable bootp, dhcp, or a...

  • Page 6

    8 q u i c k s t a r t g u i d e u d s 1 1 0 0 w w w . L a n t r o n i x . C o m 9 assign ip address continued 6. Click the assign button to finalize the ip assignment. Assign ip address continued… 5. Enter the ip address, subnet mask, and gateway being assigned to the device in xxx.Xxx.Xxx.Xxx forma...

  • Page 7

    10 q u i c k s t a r t g u i d e u d s 1 1 0 0 w w w . L a n t r o n i x . C o m 11 leds/troubleshoot the unit contains the following leds: • power • 10/100 mb link • 10/100 activity • diagnostics • status channel 1 simultaneously lit red and green leds means something is wrong. If the red led is li...

  • Page 8

    12 contact for questions and technical support, please check our online knowledge base at www.Lantronix.Com/support lantronix 15353 barranca parkway, irvine, ca 92618, usa phone:(949) 453-3990 or fax: (949) 453-3995 www.Lantronix.Com w w w . L a n t r o n i x . C o m 13 q u i c k s t a r t g u i d e...