Lap RH60B-LED Installer's Manual - 12M
The bulkhead light incorporates a PIR (Passive Infra Red) sensing device which continuously
scans a preset operating zone and immediately switches the lamp on when it detects movement
in that area.
This means that whenever movement is detected within the range of the sensor the lamp will
switch on automatically to illuminate pathways, steps, patios, porches, or whatever area you have
selected to light for reasons of safety, convenience or security.
While there is movement within range of the unit the lamp will remain on.
PARTS INCLUDED
- Luminaire c/w PIR Sensor unit.
- Instruction manual. Please keep safe for future reference.
- Accessory Pack.
TOOLS & PARTS NEEDED
- 3 core cable
- Electric/hand-held drill & bits
- Terminal or Electricians screwdriver
- Large slotted/philips screwdriver
- Wire cutters
To achieve best results, we suggest you take into account the following points:
■ Do not mount on vibrating surfaces.
■ Ideally the bulkhead light should be mounted 1.8 to 2.5 meters (6 to 8ft) above the area to be
scanned (refer Fig.1A).
appro.110°
1.8 to
2.5 meters
4M
8M