Lap RH60B-LED Installer's Manual - page 5
Important: To avoid dust build-up and ensure proper functioning of the global lamp, wipe
the sensor lens lightly with a damp cloth every 3 months. But never modify the unit, there
are no any user serviceable parts inside.
1. Put the Lux control knob to light ( ) position, turn the wall switch on and wait half a minute for
the control circuit to stabilize. At this stage ensure that the TIME control knob is set at minimum
duration time (-) position. The bulkhead light will now switch on and remain on for about 30
seconds (within 60 seconds).
2. Direct the sensor toward the desired area to be scanned by adjusting the PIR sensor.
3. Have another person move across the center of the area to be scanned and slowly adjust the
PIR sensor until the unit sensors the presence of the moving person, causing the lamp to switch
on. (refer Fig. 1B).
4. Adjust time control to required setting.
5.To set the lux level at which the lamp will automatically switch “on” at night, please turn the LUX
control knob from daylight to night. If the lamp is required to switch on earlier, e. g. Dusk, wait for
the desired environment light level, then slowly turn the LUX control knob towards the daylight
( ) while someone walks across the center of the area to be detected. When the lamp switches
on, release the LUX control knob. You may need to make further adjustments to achieve your
ideal light level setting.
220-240VAC 50Hz
9W (12X0.5W LEDs)
Approx.110º (horizontal), Max. 12 meters adjustable
and sensitivity adjustable
from (10±5) seconds to (4±1) minutes adjustable
from daylight to night adjustable
IP44
Voltage:
Wattage:
Detection range:
Duration time:
LUX control level:
Weatherproof: