Lascal BuggyBoard Maxi Owner's Manual - page 4
English
English
7. Positioning the cotter pins.
Measure the distance between the middle of
each of the connectors.
Deciding the cotter pin direction.
If the measured distance is between:
• 31-43 cm (12.4-17.2 in.) Alt. A below.
• 43-54 cm (17.2-21.6 in.)
Alt. B below.
8. Choosing the right cotter pin hole.
There are three holes in each arm. To choo-
se the hole that best suits your stroller, posi-
tion the BuggyBoard™ as close as possible to
the back of your stroller, however do make
sure that your child can stand comfortably.
Once decided, screw the cotter pin into the
chosen cotter pin hole, tighten with a coin.
If the arms are too short to fit to your stro-
ller, there is an ‘Extender Kit’ available as an
accessory, see fig 13.
6. Rotating the arms forward.
Turn the platform onto its wheels.
(A) Unscrew the height adjustment screws
(81310) until they are just released.
(B) Rotate the arms forward then tighten the
height adjustment screws.
THE ARMS
A
B
6
43 - 54
cm
31 -
43 cm
Alt. A
Alt. B
1
3
2
A
B
8
7
5.
4. Tightening the connectors
The connectors must be firmly attached to
the stroller.
5. Before you cut the strap
There is no need to cut the strap if it does not
interfere with attaching the BuggyBoard or
stroller’s folding mechanism. The strap could
be used on a different stroller in the future.
- 6 -
- 7 -
4.