Laser AS 50 Instructions For Use Manual - page 4
AS 50
V. 1.2, 26.11.2009
4
1. General
Notes
These operating instructions must be read carefully before starting the device.
These operating instructions describe the correct usage of the AS 50and also point out
any potential risks. These operating instructions are to be read and observed by all persons
who operate, use, service and inspect the device.
Please contact your supplier, representative for any related questions or you may direct your
inquiries to:
REIMERS & JANSSEN GmbH
Medical Laser Technology
Frohnacker 8, 79297 Winden, Germany
Tel. +49-7682-6558 Fax +49-7682-6640
service@rj-laser.com
www.rj-laser.com
Quality management according to EN ISO 13485:2003
1.1.
Exclusion of liability
The AS 50 should only be used for the purpose described in these operating instructions.
The manufacturer will not be liable for any damage or injuries resulting from usage not
contained in these operating instructions. The manufacturer reserves the right to make
modifications in keeping with technological advances.
1.2.
AS 50
standard
The AS 50 meets or exceeds the requirements of the following international standards:
EN 60825-1: 2003
Safety of Laser Devices
DIN EN 60601-1-2 Electro magnetic compatibility
1.3.
AS 50
principle of function
The AS 50 will emit monochromatic, coherent laser light to for the irradiation of points and
smaller surfaces. Use always with 4 mm applicator.
Further information on the wide range of the use of laser devices can be found in technical
literature and with scheduled seminars RJ-LASER GmbH(
www.rj-laser.com
).