Laser Interceptor Laser Interceptor User Manual - page 14
Sun Interference Alert Sensitivity:
Adjust your sensors sensitivity to sun. If
SIA is too high it is possible that you receive offten Sun Interfernece Alerts,
although sun is very weak.
Sun Interference recycle time:
Adjuts frequency of Sun Interfernce alerts.
Example:Set to 35 seconds, and you wil get SIA warnings every 35 sec., if sun
interference is detected.
Parking sensor duration:
Set parking aid duration on the begining, right after
«Welcome sound».
Set this parameter to
0 sec
if you want to
TURN OFF
Parking aid.
Unknow gun alert:
Enable or disable posibilty of receiving Unknown gun
alerts.If a new LIDAR is on the streets and there is still no jamming algorithm
developed, LI will run
GENERIC ALGO
and try to jamm it!
It is possible that Laser Interceptor detects some signal that isn’t LIDAR, and it
will still warn you about that.
Parking switch:
Enable or disable usage of additional Parking switch.
Optional CLOSE (switch) contacts for Parking mode (position 1) or
Optional OPEN (switch) contacts for Parking mode (position 0)
Laser detector:
Enable this feature to make Your device work as Laser detector
only. This will
TURN OFF JAMMING
as long as Your switch is set to 1
(closed contacts).
Jam duration:
Your Laser Interceptor unit will jamm every gun for unlimited
time unless you set different in this feature.
Example: If you set duration to 9 sec. than you Laser Interceptor will jamm gun,
9 seconds, after recognising it, and than it will turn off jamming sequence.
Jamm restart time:
Set time after which will your Laser Interceptor CPU turn
ON again jamming mode.
Check sensors:
Open or Close desired port plugs for outer sensors from 1 - 4.
Depending on weather you have Dual, Triple or Quad unit, you will open
additional ports if needed.
Sensor Senstivity:
In case Your sensors pick a lot of false alerts, You can
decrease their sensitivity to lower false alert rate.
USER MANUAL
14