Laser Interceptor Laser Interceptor User Manual - Creating Own Voice Files
Creating own voice files
If you like you can make your own voice files ad upload them to your control unit. Use
following procedure to make your voice pack.
1. Record or download warning that you want to hear from LI CPU instead unwanted
file,and convert it to
.pcm
file! For converting you can use similar program like this and
use them same setings like on pictrue.(sample rate - 11025Hz;mono;8-bit)
2. After converting your file rename it with number of unwanted file.
3. Here is a list of voice files with numbers that Laser Interceptor uses, so you can know
which file you want to remove from your CPU:
1 - Silence (reserved)
2 - Silence (reserved)
3 - Jenoptic, Jenoptic Clone or Ultralite LTI 20.20
4 - Marksman or Ultralite 20.20
5 - Kustom Pro One
6 - Laveg
7 - Kustom Pro 3 or Pro Lite
8 - Laser Atlanta or Kustom Pro 2
9 - Laser Atlanta Stealth Mode
10 - Stalker Lz1
11 - Riegl
12 - Interference from sun detected, please proceed with caution
13 - Jamming sequence is activated, please slow down
14 - Parking aid is deactivated
15 - TruSpeed
16 - Unknown gun
17 - Warning
18 - Siren 1 (main alarm)
19 - Welcome
20 - Please call service
21 - Beep (for parking)
22 - One
23 - Two
24 - Three
25 - Four
26 - Connections to sensors
27 - Are poor or bad
28 - Parking aid is activated
29 - NJL SCS 102
30 - TraffiPatrol XR
31 – Siren 2 (warning alarm)
32 - Detected radar in
33 - Ka
34 - K
35 - X
36 - Band
37 - TSS Laser 500
38 - Beep (for end jamm time off)
39 - Traffic Observer
40 - Rapid Laser
41 - Vitronic PoliScan Speed
42 - Entrance in the section speed control
43 - Exit from the section speed control
44 - Please slow down
45 - Unipar 700
46 - Photo camera
47- Know gun
48 - Silence (reserved)
49 - Silence (reserved)
4. Copy/paste your new file to original LI voice pack and upload to CPU.
USER MANUAL
15