Lassco Spinnit EBM-2.1 User Manual - page 7
3 - Setting Up Your Machine
3.3 - Installing the Table Assembly
Page 06
Grasping the Table and depressing the Release Handles to unlock
the Release Pin, slide the V-Bars located on the underside of the
Table into the V-Rollers on the Base of the machine as shown.
Please note that one of the Table Stops (EZ-1014) comes in-
stalled. Make sure when installing the Table onto the Base you
are sliding it from right to left (while facing the machine) to avoid
obstruction from the pre-installed Table Stop.
Please note that, although they are factory set, you may have
to adjust the cams on the V-Rollers if the Table is too tight or too
loose after installation. If so, remove the Table. With an open-end
wrench and holding the screw head in place with a screwdriver,
adjust the cam spacers under the V-Rollers. If the Table is too
tight, adjust the V-Rollers out towards the edge of the Fork Plate
(EZ-1000). If the Table is too loose, adjust the V-Rollers in toward
the center of the Fork Plate.
3.3.1
3.3.2
3.3.3
Diagram 3-10
V-Bars
Release
Handles
Underside of Table
Release Pin
Table Slide Stop
Diagram 3-30
V-Rollers
Cam Spacers
Fork Plate
Diagram 3-20
1/4” Lock Washers
10-32 Elastic Stop Nuts
Diagram 3-40
Attach the second Table Stop (EZ-1014) to the underside of the
table using two (2) 1/4” lock washers and two (2) 10-32 Elastic
Stop Nuts as shown. Tighten with a wrench until secure.
3.3.4