LauraStar Steam Cleaner Quick Start Manual - page 4
- 3 -
- 4 -
CAUTION: Always fill the water reservoir completely for best
performance.
NOTICE: Operating the appliance without water can damage the
appliance and will void any limited warranties provided with
your appliance.
Filling
•lift the cover of the water reservoir and remove the reservoir by
pulling on the cover. Insert the filter cartridge (18) provided and fill
with tap water.
•Replace the reservoir (4) by lifting the cover, then close.
Switching on your appliance
•Plug in the iron.
•Press the On/Off switch (7); the white indicator light will flash for
3 minutes.
•When the white indicator light stops flashing, the appliance is ready.
NOTE: For your comfort and safety, your Laurastar steam station
will switch off after 10 minutes of not being used.
NOTE: Before ironing, or after an extended break, press the iron’s
steam button 2 or 3 times, while pointing it away from the clothes.
This will release any condensation from the iron and prevent
water marks on the clothes.
WARNING: Do not point the iron at people or pets while
using vertical steam.
Installing your steam station
•Remove the appliance from the box using the handle (20) and place it
so that it is level, on a flat, stable and fire-resistant surface.
•fix the cable holder (6) on the ironing board and slide the steam hose into
it (3) (only available with certain models. This can also be obtained at
www.laurastar.com or from an approved laurastar retailer).
Which water should be used?
your laurastar has been designed for use with tap water. However, we
recommend using the filter cartridge provided in order to extend the
service life of your laurastar.
NOTICE: Never use additives (e.g. perfumed water), water
containing chemical products or water from tumble dryers as
these products will have a detrimental effect on the function of
your Laurastar.
DANGER!
KEEP OUT OF REACH OF CHILDREN.
DO NOT DRINK the filtered water.
Storing your steam station
•Switch off the appliance by pressing the On/Off switch (7) and unplug
the plug (16) from the outlet (16).
WARNING! Leave the appliance to cool for at least
2 hours before storing.
•When the appliance is completely cooled, place the insulating mat (5),
followed by the iron (2), onto the appliance.
•Wrap the electric cable (17) around the appliance. If your model
includes the automatic winding mechanism (19) (only available on
certain models), pull on the electric cable to trigger automatic winding.
Wrap the steam hose (3) around the appliance.
•you can leave water in the boiler until the appliance is next used.
B
C
Start up
Installation and storage
Ironing
Setting the temperature of the iron
Setthethermostat(12)to••or•••.
NOTE: After changing the temperature setting, it takes
approximately 2 minutes before the new temperature is
stabilised.
A
B
A
B
A
A
B
A
C
EN