LauraStar Steam Cleaner Quick Start Manual - page 7
- 9 -
- 10 -
Problems and solutions
Before calling the laurastar Customer Service department, please check the following points :
Return to the Customer Service department
Switch off the appliance and disconnect the plug. locate your purchase contract, invoice or receipt.
Telephone the Customer Service department and follow the instructions given.
Technical characteristics
Declaration of CE conformity
In sole responsibility, we declare that these products comply with the standards or standardised
documents of the applicable european directives.
eU directive on electromagnetic compatibility 2004 / 108 / eC
eU directive on low voltage 2006 / 95 / eC eN 60335-1 eN 60335-2-3
eN 55014-1 eN 55014-2 eN 61000-3-2 eN 61000-3-3 eN 61000-6-2
eN 50366 eN 62233 IeC 62233
IeC 61000-3-2 IeC 61000 3-3 CISPR 14-1 CISPR 14-2
eU directive on the use of certain hazardous substances in electrical and electronic equipment
2011 / 65 / eU
Patent pending
Technical information
CE
UL
Total output
2200 W
1700 W
Generator output
1400 W
1100 W
Iron output
800 W
600 W
Steam pressure
3,5 bar
50 psi
Reservoir capacity
1.1 l.
37.2 oz.
Electricity supply
220-240 VaC, 50 / 60 Hz
120 VaC, 60 Hz
Weight of iron
1 kg
2,2 lbs
Total weight
5,5-6 kg
12,12-13,22 lbs
Dimensions (H x L x B)
46 x 28 cm x 28 cm
17,94 x 10,92 x 10,92 in
IRON
Symptom
Likely cause
Remedy
The soleplate drips.
•
The iron is not ready.
•
The thermostat (12) is incorrectly set.
•
The appliance has not been drained
recently.
•
The reservoir has been rinsed with a
product other than water.
•
Wait until the white indicator light on
the On/Off switch (7) stops flashing.
•
Set the thermostat – page 4.
•
drain the appliance.
•
Call the Customer Service
department.
The iron does not heat up.
•
The plug (16) is disconnected.
•
The On/Off switch (7) is off.
•
Connect the plug.
•
Switch on the appliance.
The iron is too hot.
The thermostat (12) is incorrectly set.
Set the thermostat – page 4.
ST
EA
M
G
EN
ER
AT
O
R
Symptom
Likely cause
Remedy
Makes a buzzing noise when steam is
emitted from the iron.
Generator vibration (1).
This noise is normal for a new
appliance, it will disappear in the
course of use.
Makes a crackling noise when the
appliance is switched on.
The appliance has been set to heat up. This noise is normal when the
appliance is heating up.
The white indicator light flashes
during ironing.
The water has been reheated.
The appliance is working normally.
The iron no longer emits steam. The
pressure has fallen.
•
The reservoir (4) is empty.
•
The appliance is switched off.
•
The plug (16) is disconnected.
•
fill the reservoir with water – page 4.
•
Press the appliance’s On/Off switch
(7).
•
Connect the plug.
The light remains red when the
reservoir is full.
The reservoir has not been correctly
replaced.
Remove the reservoir and replace it
correctly in the base, with the cover
open.
laURaSTaR lIfT +
Type: 12-HG-0142
Model: 525
laURaSTaR lIfT +
Type: 12-HG-0142
Model: 520
laURaSTaR lIfT +
Type: 12-HG-0142
Model: 515
laURaSTaR lIfT
Type: 12-HG-0142
Model: 510
laURaSTaR lIfT
Type: 12-HG-0142
Model: 505
laURaSTaR lIfT
Type: 12-HG-0142
Model: 500
EN